![]() ![]() Please use the latest firmware version of the transceiver. The IC-9100, IC-7600, IC-7410, IC-7300, IC-7200 or IC-7100 can be connected to a PC with a USB cable and the input/output audio signal and CI-V command is sent through the USB cable.Äepending on your transceiver, some functions or modes cannot be used, or you need to update the transceiver’s firmware. The IC-7851, IC-7850, IC-7800 or IC-7700 has a built-in Network function, so only an Ethernet cable is needed. ![]() It provides a high speed, high resolution spectrum scope equivalent to the main unit (For a single band on only the IC-7851, 78). View the spectrum scope with the waterfall function. Slider control or tuning knob control screens are selectable for RF power, CW pitch, RF gain, and SQL and AF level. Several separate windows for CW keyer settings, voice memory, SSB passband settings for both transmit and receive, and filter settings. This Icom exclusive software gives you most functions and modes from your Icom transceiver in your ham shack. Remote power ON/OFF function wakes up the IC-7600 from standby mode. Most functions and modes of your transceiver, including interference rejection functions and IF filter settings, can be controlled using CI-V commands. ![]() Low latency provides the same operational experience as using an actual radio plus high quality audio over an IP network. As long as you have internet access, you can get on the air. The RS-BA1 V2 allows you to use your ham shack at a distance, whether you are in another room in your home or in another state.
0 Comments
Leave a Reply. |